Industrial Machinery

WITT Gas Controls to Showcase Gas Mixing, Pressure Regulation and Safety Valves at FABTECH 2026

The company plans to discuss MEM+ mixers, dome pressure regulators and ULTRA safety valves at Booth S46114 in Las Vegas.

Maren OstergaardOctober 25, 20265 min read3 views
A brushed stainless-steel gas mixing cabinet with valves and regulators sits on an exhibition plinth as gas inlet lines converge toward a single outlet.

WITT Gas Controls plans to exhibit at FABTECH 2026, scheduled for Oct. 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada. At Booth S46114, the company will discuss its MEM+ gas mixers, dome pressure regulators and gas safety valves, focusing on precise mixing, stable pressure and system protection.

MEM+ gas mixing

WITT says the MEM+ series is designed to mix two or three non-flammable gases, including nitrogen, carbon dioxide and oxygen, across a range of industrial applications. The mixers use electronically operated motorized proportional valves that can be adjusted in 0.1 percent increments. According to the company, a desired mixture can be achieved in less than three seconds with accuracy better than ±1% absolute.

Seven interface options, including Ethernet, OPC UA and PROFINET, are intended to support integration with existing systems. Users can operate the mixers remotely through a PC, PLC or machine controller, or directly through a touchscreen interface. WITT presents these options as a way to connect the mixer to different control arrangements.

For stable operation, pressure equalization compensates for supply pressure fluctuations. Continuous inlet pressure monitoring and pressure alarms are included, and an integrated buffer tank accommodates fluctuating flow rates. The MEM+ units are housed in a splash-proof, brushed stainless steel enclosure and support maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar. The maximum pressure figures define the operating limits WITT cites for the series.

Pressure regulation and protection

WITT will also highlight its dome pressure regulators, which feature optimized pilot pressure regulators designed to maintain stable working pressure despite changes in flow rates and inlet pressures. The company says the design is intended to support consistent process performance and product quality. The improvements can be retrofitted to existing WITT dome pressure regulators without replacing the complete system, according to WITT, offering a way to update existing installations. The company positions the retrofit as an alternative to replacing the complete regulator assembly.

The exhibit will also cover ULTRA non-return valves and ULTRAVENT safety relief valves. ULTRA non-return valves combine low opening pressures, tight sealing and minimal flow resistance to protect gas systems against unwanted backflow. ULTRAVENT safety relief valves are designed to protect against excessive pressure and respond to pressure increases as low as 5 mbar.

Exhibit focus

WITT Gas Controls describes itself as a global leader in gas safety, control and analysis solutions. The planned FABTECH exhibit is aimed at industrial users seeking tighter gas mixture control, stable pressure regulation and protection for gas systems. Attendees are invited to Booth S46114 to discuss the products and their applications with the company. The booth discussion is expected to center on those three themes: mixing accuracy, pressure stability and system protection.