Building Materials & Real Estate

Surveying drone strikes tower crane at Manchester construction site

An AAIB bulletin says the drone hit the crane despite obstacle avoidance being enabled, then fell about 120 m.

Nadia OkonkwoNovember 12, 20265 min read1 views
A conceptual illustration of a surveying drone flying near the jib of a tower crane above an urban construction site under an overcast sky.

A surveying drone struck the top of a tower crane at a construction site in the Cheetham Hill area of Manchester in August, according to the Air Accidents Investigation Branch (AAIB).

The unmanned aircraft was carrying out an aerial survey on a pre-selected flight path over an urban construction site when the collision happened. Although the obstacle avoidance feature was enabled, the drone hit the top of the crane and fell about 120 m to the ground.

The AAIB said the incident had been notified to it, but no formal investigation was launched. Neither the site nor the contractor was identified in the bulletin.

Software limitations cited

An internal investigation by the construction company found that the company and its remote pilots may not have fully understood the limitations of the obstacle avoidance software, the AAIB reported.

The bulletin does not state whether anyone was injured, what damage resulted, or what operational or regulatory changes have followed. It also gives no details of the aircraft's make, the purpose of the survey, or the crane's height relative to the planned flight path.

The account points to a gap between automated collision-avoidance features and the conditions found on working construction sites, where cranes and other structures may sit outside a system's expected detection range. The AAIB attributes the outcome to a possible misunderstanding of those limits, rather than to the feature being switched off.