High strain rate testing can give engineers the material data needed to make crash and impact simulations more representative of real loading, according to Andrea Incardona, application engineer and product specialist at testing machine manufacturer Instron. His argument, made in an article for the company, is that the value of a simulation depends on how accurately the model represents the material itself, and that conventional quasi-static characterisation may not capture how a material behaves once loading becomes rapid.
Many materials exhibit strain-rate-dependent properties, so their mechanical response changes as loading speed increases; a component characterised only under quasi-static conditions may therefore respond differently in a rapid impact or crash event. Incardona cites a 2025 study in the SAE International Journal of Materials and Manufacturing, "Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures". According to the article, incorporating strain-rate-dependent material properties into crash simulations reduced the gap between simulated and experimental results: the discrepancy in peak acceleration fell by 6.5 per cent, while mean acceleration and displacement discrepancies fell by 5.9 and 6.3 per cent respectively.
Incardona draws a narrower point from that work: the relevance of material data matters as much as its quantity, because a model built on data from the wrong loading regime cannot correct for behaviour it was never given.
According to Instron, materials can be characterised from quasi-static conditions up to strain rates approaching 1,000/s, depending on the material, specimen geometry and test method. Tests may last only 3 to 10 milliseconds, which puts heavy demands on data acquisition, since the system must resolve rapid changes in force and deformation within a very short window.
Rate effects in selection and design
Incardona argues that strength and stiffness alone do not show how a material will respond when loading becomes rapid. Two materials that appear comparable in conventional testing may deform, absorb energy and ultimately fail differently under high strain rate conditions, a distinction that matters where performance has to be balanced against weight, as in automotive crash structures or aerospace components.
He frames dynamic characterisation as part of a development loop: measure material behaviour, incorporate it into simulation, use the model to compare design options, then validate through physical testing. Applied earlier in a programme, such data can help engineers judge whether a material is suitable and refine a component design, rather than acting only as a final check on an existing design.
Instrumentation claims
Instron says its high strain rate testing systems support data acquisition at up to 200 kHz, while digital image correlation can add information on how strain develops across the specimen; analysis tools then support data processing and theoretical modelling. The company presents the result as a more connected development process in which physical testing feeds simulation, material selection and design refinement.
The article's closing point is a limit as much as a promise: material data is only as useful as its relevance to the conditions a component will actually face, and a model built on quasi-static properties alone may be unable to represent the conditions experienced during a rapid event.
