Researchers at Northwestern University have developed a hybrid 3D printing method called direct ink additive lithography, or DIAL, that is designed to print thick, particle-filled extrusion inks at speeds and resolutions closer to those of light-based processes. The work, led by Pranav Kaarthik, was published in Science Advances.
The method addresses a trade-off between two established approaches. Digital light processing requires low-viscosity, weakly scattering resins, while direct ink writing can handle functional yield-stress inks but is slowed by filament deposition and limited by nozzle diameter. DIAL combines elements of both to widen the range of printable materials without giving up projection-based patterning.
How the process works
For each layer, a slot die extrudes ink onto a substrate, and a doctor blade spreads it into a sheet as thin as 25 microns. A 405-nanometer projector then moves over the sheet and crosslinks selected regions; uncured ink remains in place and acts as support. Because light passes only through a thin sheet, opaque and heavily filled inks remain printable. The projector's 50-micron pixel pitch sets the planar resolution.
The researchers tested the process with a model ink made from a polyurethane-based resin thickened with fumed silica. They printed a 60 mm by 40 mm log pile structure in 30 minutes, compared with 124 minutes using direct ink writing, and produced fins about 150 microns thick. Rastered projection over overlaid ink sheets also produced a multimaterial lattice covering four times the projector's illumination area.
Demonstration parts
The team printed interlocking chain mail with struts about 250 microns thick and produced 15 gyroid structural electrolyte lattices from an ionogel ink in a single 15-minute run. It also made hydrogel cell culture inserts containing 0.5-mm-deep inverted pyramids. These examples span mechanical structures, ion-conducting architectures and biomedical labware.
The authors described their print times as conservative because tool changes had not been tuned for speed. They also said the absence of suction and peel forces found in vat-based printing should make it easier to expand the build area and volume. Those points concern the method's development path; they do not establish that DIAL is already a high-volume manufacturing process.
Ryan Truby, June and Donald Brewer Junior Professor of Materials Science and Engineering at Northwestern University, said manufacturers have had to choose between needed materials and desired printing speed, resolution and scale. He said DIAL lays a foundation for eliminating that compromise. Truby also said the ability to print many complex functional parts at once offers a path toward scaling the process from the lab to larger-volume production of architected materials for robotics, aerospace, healthcare and other applications.
Kaarthik and Truby are listed as coinventors on a U.S. provisional patent application. Funding came from the National Science Foundation, the Air Force Office of Scientific Research and Northwestern's McCormick School of Engineering.
